ST-LINK/V2 (mini)

Mini ST-LINK/V2 on a small single board, an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32.

Features

• Onboard 500mA self-recovery fuse to avoid harming by short circuit
• Dual voltage output (3.3V/5V), easy for debugging/programming
• Standard USB interface for direct connection to PC
• Debugging/Programing performance
•  * Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
•  * Programming : supports FLASH ROM, EEPROM, AFR, etc.
• USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming
• Upgradable firmware
•  * The firmware is upgradable to support more devices in the future
•  * Automatically upgraded
• Supported software
•  * ST-LINK Utility v2.0 (or higher ver.)
•  * STVD Version 4.2.1 (or higher ver.)
•  * STVP Version 3.2.3 (or higher ver.)
•  * IAR EWARM Revision v6.20 (or higher ver.)
•  * IAR EWSTM8 Revision v1.30 (or higher ver.)
•  * KEIL RVMDK Revision v4.21 (or higher ver.)
•  * ATOLLIC
•  * TASKING
• Supported devices
•  * All the STM8 devices with SWIM interface
•  * All the STM32 devices with SWD interface
• Click for resources.

Connecting with PC

While connecting the ST-LINK/V2 (mini) to the computer through USB interface, the USB driver is required and should be installed correctly first.

Click on the link to download : ST-LINK/V2 USB driver for Windows 7, Vista and XP